THE PROBLEM SOLVER   
 
 
MAXAM® Selection Guide

When conditions exist outside the standard parameters or any of the following conditions exist, consult our MAXAM Sales specialist.
  • Rotational speed at wear surfaces exceed 100 SFPM, whether lubrication and cooling is frequent or continuous.(as shown in chart).

  • Mild acid solutions exist and are used as a lubricant. (alkaline not a problem)

  • Continuous and strong thrust loads exit.
With the cost of a bearing usually forming approximately 10% of the total cost of repair, the MAXAM® is a cost saver. Several industries have found the MAXAM to be a very successful PROBLEM SOLVER. These include primary metals, foundries, material handling, rubber, chemical, mining, off-road equipment, water and waste treatment, food, pulp and paper.
© 2002 McNeil Industries All rights reserved
MAXAM® is a registered trademark of McNeil Industries.
This page was updated: 05-Jun-2002
Best viewed at 800x600 resolution.
Contact the webmaster

Home   MAXAM  12 Reasons  Selection Guide   Where to Purchase  Contact Us